KLOCK WERK WFB BENCHMARK FRONT FENDER
Let's start by talking about the quality of all of Klock Werks Sheetmetal. It's unmatched! Klock Werks has gone the extra mile with ALL of their metal and had it stamped from 14 gauge US STEEL - the REAL DEAL folks - to ensure a consistent flawless finish while minimizing bodywork. All fenders and fillers are pre-drilled and they FIT, allowing for easy installation. AND, they are E-Coated to prevent rust and corrosion. These bad boys are just screaming for fresh paint and painters love Klock Werks sheetmetal - one coat of fill primer and they are ready to paint (which saves YOU money at the paint shop!)
This is one stout fender with a little KICK! It is our new stamped front fender for the Kustom Bagger Set - with versions available for your SOFTAIL too! It is stamped out of cold rolled US steel. It has been E-coated to prevent rust and corrosion. Mounting tabs are just right to fit over a 16/18" or 21" front. PRE-DRILLED. They FIT!
The Klock Werks Benchmark Front Fender gets rid of those ugly rivets and big fender mount brackets. The tail of the fender is extending 1 1/2" for a dropped and slammed look and better matches the stock fender and perfectly matches our Benchmark Rear versions. The fender rides tighter to the tire with adequate clearance and yet minimizes that stock Dirt Bike level that the factory bikes are famous for. E-coated for minimal bodywork and easy painting, all holes are laser cut so it takes the guesswork out of getting the right clearances and getting it on straight. We make it quality, you paint it your way and make it Kustom!
Mounting Blocks required for BAGGER front fender, part numbers: 1410-0022, chrome; 1410-0023 raw
Fits 83-09 FLT, FLHT, FLHX, FLHR, FLTR models
NO mounting blocks needed for softail models. Fits 84-07 SOFTAIL MODELS (except FXSTD and Springers) AND CUSTOM APPLICATIONS
